Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

12.06.2025 06:41

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

One is “what exactly is in a ‘surge protector’ ? ”

One

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

A 'Crazy Idea' About Pluto Was Just Confirmed in a Scientific First - ScienceAlert

the problem then depends on "how fast does the fuse operate?".

The other is “what does a “fuse” do?”

There are three different concepts here that are getting confused.

I have the power to talk to aliens through using telepathy. Why do people think I'm crazy?

This is where the MOV conducts again, and dissipated the energy.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

There are two important concepts here.

I am 11 years old and I think I am going through puberty. Why do my nipples hurt when I touch them? Is it normal?

but I think this circuit , shows a few more pieces.

eight

The bolt then partially travels down the line to your home.

As a woman, what would be you response to a male friend’s offer of a full body massage?

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

2024–10–14 [Omar Gharbi Omar Gharbi ]

State of Play Confirmed for 4th June, 40+ Minutes of PS5 Games - Push Square

nine

So, the voltage could go up to 500 volts, and the fuse will not open up.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

Gwyneth Paltrow Is Not Breaking Up With Dakota Johnson Following Chris Martin Split - The Daily Beast

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

The third is lightning and “how it gets conducted into a home.”

NASA Discovers Strange X-Shaped Structures in Earth’s Upper Atmosphere - Indian Defence Review

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

Upvotes:

Here is a simplified AC power diagram.

Have you ever answered your door in lingerie?

2024–10–16 [ OO OLAOYE OYEBODE ]

I post the exact comment here.

But it can get overloaded, and no longer works.

How do scientists behave?

A fuse is a non-resetable over current circuit protector.

but this device (an Inductor) … impedes the rapid changes in the current.

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

New Nintendo Switch 2 Welcome Tour demo trailer shows off mini games and tech demos in-action - Eurogamer

These are simplified answers to the original question, and does not change anything I wrote above.

He then describes Rainy Season and Lightning.

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

As Cannabis Users Age, Health Risks Appear To Grow - KFF Health News

Edit 2024–10.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

A circuit breaker is similar, but is resettable.

what exactly is a ‘surge’ protector?

so, what happens?

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

It seems Mohan does not understand the difference between a comment and an Answer.

Barnstars:

Now when you have a certain ac resistance, then a current flows in a loop.

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

He then asserts :

At one ohm, the resistor has a maximum of 1 watt power.

What does a fuse do?

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

He then describes the function of a fuse.

An AC voltage/ current source, and an ac inductive load.

In schematic diagrams this is the symbol for a fuse:

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

It also is a device that limits the change in current flow.

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

These devices are installed between the “hot” and “neutral” and protective ground.

This one hit behind the barn.

[image of Common-mode choke]

Can the fuse protect the electronic devices from lightning instead of a surge protector.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

2024–10–10[John johnson John Johnson ]

This is 'the assistant's answer'

But… the neutral is now “floating” because of the 1 ohm resistance.

What is lightning?

(Dc diagram shown, AC is similar).

For this case there are devices called Metal oxide varistors (MOV).

The MOV will conduct when the voltage exceeds 50% of line voltage.

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

This device then solves the entire problem.

[old diagram got deleted by accident]

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

This is where this question deviates from being a 'generic' question, and becomes more specific.

Because the load is inductive, the current lags the voltage.(by a bit).

At least they know the answer if they wanted it.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

This is the picture of an electronic coil of wire wound around a core of magnetic material.

a photo is worth a thousand words.

First Sentence:

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.